What are the Different Methods of Cutting Rubber?

There are many different methods of cutting rubber, however, the most common methods are presented in this article.

Manual Cutting

Manual cutting is the simplest way to cut industrial rubber products, often done with a box cutter or bladed knife. Typically, an employee will position the material on a work surface and create a stencil or template for use during cutting. With edge trim that contains metal wire, guillotine cutting is used instead.

The cost effectiveness of the manual cutting method is completely dependent on the skill of the employee. It might seem cost-effective at first, but after taking the true cost of rework and material waste into consideration, this is rarely the case. Manual cutting cannot compete with other methods when it comes to producing products with tight tolerances and precise shapes. It also increases the risk of employee injury.

Die Cutting

The die cutting process is very straightforward. Steel dies are created and used to stamp out parts, like a cookie cutter. There are three common methods within the die cutting method that are used in industry, these are the flatbed, rotary and digital die cutting methods. Although the digital die cutting method is considered die cutting, it differs largely from the other two in that it does not actually involve a die, but a tool like an oscillating blade that cuts out the desired shape. Flatbed die cutting is slow but can process thicker materials than the other two methods. Rotary die cutting is faster than the other two methods and is very accurate, but initially expensive. The digital die cutting method is also initially very expensive but is highly accurate and, in contrast to the other two methods that are limited to the available dies, can cut any shape by simply programming it to do so.

The die cutting method can be used for:

  • Through cutting – cutting through the entire material so the piece can be separated from the whole.
  • Scoring – this process does not cut through the whole material. It just indents or partial cuts into the material to make it easier for folding and other processes.
  • Kiss cutting – this cut is specifically for adhesive-lined materials because it goes through everything but the backing material layer.
  • Perforating – creates a series of punch-through holes so the piece will not be fully removed from the whole material.
  • Broaching – when the material is particularly thick, it may require this specialized form of die cutting.

Just like the manual cutting method, the die cutting method puts pressure on the material in such a way that can cause bevelling and edge distortions – especially with softer elastomers. This happens no matter which type of die is used.

For prototyping and low-to-medium volume production, especially when tighter tolerances are required, the laser and water jet cutting methods make more sense.

Water Jet Cutting

This technique uses extremely high-pressure water streams to precisely cut shapes out of a given material, and as such does not require tooling. This eliminates costs, speeds up prototyping, and reduces lead times on new production.

Water jet cutting does not deform rubber materials in the same way that manual and die cutting does, so, cut edges are not rough or bevelled and tight tolerances can be achieved. Water jet cutting can also create notches, angles, holes, dovetail cuts, and other part features.

For cutting thicker and harder materials, an abrasive sand can be added to the water to increase the cutting capabilities of the water jet cutting method.

Laser Cutting

A direct and focused laser beam can cut at amazingly high detail levels, which means very tight tolerances even on very small pieces. This cutting method is particularly useful on thin rubber sheets or compressed fibres and adhesives.

These cuts produce very clean and smooth edges since the laser can get hot enough to literally vaporize the material it is going through.

A laser cutting machine can be programmed with highly detailed plans and still deliver a quick turnaround at various levels of production. This makes it great for prototyping since it can be used for small runs or test runs before creating dies for an extensive production schedule.

Lasers can be used for more than just cutting, too. As a part of the production process, lasers can be used for annealing, drilling, engraving, etching, scoring, perforating, and more.

On top of that, a laser can handle several processes at once – like cutting, marking, and engraving – without having to re-fixture the sheet of rubber.

Contact Us